24
barcode. Position it until the
Barcode reader
beeps, indicating the barcode has
been scanned. When the reading has been completed, it will appear next to
ID
.
ID
will reflect the last barcode read by the reader. It will change every time a new
barcode is read until
START
is pressed to begin the test.
If a
Barcode reader
is not installed, enter the
ID
manually using the keypad.
Press
CANCEL
to clear the input,
START
to begin the test.
Press
MENU
to change the current testing mode.
After the barcode is entered,
ID
will display. Review the ID before testing the
strip.
Press
START
after the
ID
has been entered to display the next screen.
Press
START
again to begin strip testing. The strip is tested the same as other
single test modes. The results screen will show the sample ID in the
ID
field.
If
Auto-print
is
Off
, press
from the results screen to print results. Press
CANCEL
to return to the previous barcode entry screen.
Strip Test – Continuous Test Mode with Barcode reader
If
Barcode reader
is
On
and
is displayed, samples are tested in batch mode.
