The two roof panels can now be placed into
Position making sure that the top of each roof
panel drops into the cutout at the top of the
front and rear panels
Take the front bar panel and post and place into position.
Make sure that the front of the bar panel is flush with
spar on the rear panel.
Screw the bar front panel into the rear panel as shown.
3 holes 75mm screws.
Next make sure that the bar panel is at a right angle
from the rear panel. This can be done by taking a meas-
urement from the side panel to the bar panel which is
approx 970mm and placing the bar front to this meas-
urement at the end where the post is fitted.
When this is done screw the bar front to the floor. 2
holes 75mm screws.
Once the roof has been screwed into
place all the front, rear and side panels
can be screwed into the floor in the
holes provided. 5 x 75mm screws.
Moving to the inside screw the 75mm
screws at an angle through one roof spar into
the other spaced accordingly in 4 places.
Make sure that both roof sections are as
close as you can get them as in. This has to
be done in situ as the angle of screw can be
different in different situations, which is
why there are no pre drilled holes for this.
With the roof in place screw the 5 x 75mm
screws through the roof frame into the side
Panel to secure the roof both front & rear.
