Fisheye FIX NEO Mini 1000 WR FS, User Manual

- 22 -

- Please set the light output to within 25% when this product needs to be used on land.
- Use caution when handling the light head as it may get extremely hot and you may get 

burned depending on the use environments.

CAUTION

- When the light enters Safety Mode, start surfacing immediately.
- Please note that the remaining light time may differ from the actual light time due to the 

battery condition or the usage circumstances such as the surrounding water temperature.

CAUTION

High Temperature Protection Mode 

Turning off the light

Press and hold the Power/Light Output Adjustment button for a few seconds.

Protection mode automatically engages when the light head becomes over 60°C (140°F) during 
use  and  decreases  the  light  volume  to  20%  of  maximum.  [Hot]  indicates  this  high  temperature 
condition and is displayed on the LCD panel. When the High Temperature Protection Mode 
engages, turning off the power and cooling down the light head is recommended. Please be 
careful not to touch the light head with bare hands when it is very hot. The functions will go back to 
normal mode when the temperature drops below 45°C (113°F).

Safety Mode

When the battery is almost exhausted, the light output drops automatically to 20%, and the LCD 
blinks red. The light turns off after enters Safety Mode in approximately 10 minutes.

Flashing signal mode

Turning on the Wide Beam

Flashing signal mode activates by holding down the Power/Light Output Adjustment Button for a 
few seconds. Pressing the Power/Light Output Adjustment button for a few seconds returns the 
light output to the Red Beam.

Turning on the Red Beam

Flashing signal mode activates by holding down the Power/Light Output Adjustment Button for a 
few seconds. Pressing the Power/Light Output Adjustment button for a few seconds returns the 
light output to the Wide Beam.

When initially powered ON, the NEO Mini will always start with 100% Wide Beam. This product is NOT 
designed to memorize the light output setting when the power is turned OFF.

NOTE