F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar
- 62 -
F1300N.2 Rev 01
TROUBLESHOOTING
Ways to adapt the quality and finish of the dispense process are described below.
Fluid Dispense Pressure
An increase in the dispense pressure will increase the flow rate of
the fluid material being dispensed from the syringe barrel,
cartridge or valve being used for the application.
A higher flow rate means, higher volume of fluid material
dispensed.
Rotation Speed
An increase in rotation speed will reduce the total time that the
dispense tip is passing over the dispense location. This will cause
less volume of fluid material to be dispensed onto the dispense
location.
Dispense Angle
An increase in the dispense angle may lead to an over lapping of
fluid material. 360°, is one full rotation. 450° is one full rotation
plus 90° over lapping of fluid material.
Tail Angle
The tail angle can be used to over travel past the point at the end
of the dispense angle in a continuous motion. This can drag or
pull thicker material to stop a “stringing” affect at the end of the
dispense cycle and create a smooth finished joint between the
start and end of the dispense bead.
Rotation Delay
An increase in the rotation delay will show a rise in the time
before the motor starts moving. This will allow material with a
higher viscosity or low flow rate to be dispensed onto the work
piece before the turntable starts to rotate.
Dispense Delay
An increase in this time value will delay the start of the material
flow after the turntable has started rotated.
This can be adjusted to eliminate the acceleration phase of the
turntable and ensure that material is dispensed onto the
workpiece at a linear speed, to reduce a buildup of material at the
beginning of a dispense cycle.
Summary of Contents for F1300N.2
