F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar
- 9 -
F1300N.2 Rev 01
7.
HMI Display
The HMI display is used to,
- Enter the parameters of the program cycle.
- Manually actuate individual components of the machine.
- Adjust machine settings.
For full information on the HMI Display functions please refer to “HMI
Controls” section.
8.
Pressure
Regulator
Adjusts and sets the amount of pressure being used to pressurize the
fluid material in the syringe barrel or cartridge. Or, if using a pneumatic
dispense valve, then this will set the amount of pressure being used to
actuate the valve during the program cycle.
To reach the desired pressure, turn the knob counterclockwise to a point
below the required pressure, and then turn the knob clockwise to reach
the required pressure.
The regulator can be locked into position by tightening the jam nut behind
the knob against the fitting on the front panel of the machine.
9.
Start Button
Press both start buttons (5) and (9) simultaneously to actuate the machine
and begin the program cycle.
Summary of Contents for F1300N.2
