F1300N Rotary Table Operating Manual
Section 2: Setup
Rev A, February 2018
© 2017 Fisnar Inc. l Website:
www.fisnar.com
l E-mail:
info@fisnar.com
13
3
Setup
The F1300N Rotary tables are available in many different configurations. The configuration of
each machine and the accessories used with each system will depend on the customer’s
application.
The steps required to setup a system using a 30 cc or 55 cc barrel are listed below.
3.1.
If the system is being used in the European Community, the rotary table must be
placed in an enclosure supplied by Fisnar Inc. distributors. The enclosure will prevent
the operator from entering the rotary tables work area and will generate an emergency
stop signal if the enclosure’s door switch is opened while the rotary table is running.
Connect the external start / stop box and door switch or light curtain to the Ext. Control
connector on the main unit. For further information, see Error! Reference source not
found. Ext. Control Connector.
If an enclosure is NOT being used, the enclosure door switch can be bypassed by
connecting the plug labeled SHORTED (included in the rotary table accessories
box) to the Ext. Control Connector.
3.2.
Standard systems are shipped with a barrel holder, which
must be mounted on the Z head of the rotary table. The
barrel holder will hold a 30 cc or 55 cc barrel on the rotary
tables head. An optional valve / cartridge bracket assembly
may be used as a replacement for the barrel holder if the
application so requires.
3.3.
Mount the barrel holder or valve bracket assembly on the Z
axis head as shown, using two screws. The barrel holder
has several sets of mounting holes to allow it to be
mounted at different heights. Choose mounting holes which
give maximum work piece clearance but allow the tip to
reach all areas on the work piece where dispensing is
required.
