F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
34
© 2012 Fisnar Inc.
1.3
Line Passing
Registers the current XYZ location as a Line Passing point. This is a location on the line
where the tip changes direction, such as at the corner on a rectangle.
1.4
Circle
Registers a circle, where the circle‟s center is at the current XYZ location. To register a
circle, jog the tip to the circle‟s center and press
F1/ENTER
, and then press the key 4 (for
circle). The display will prompt you to type the following data:
Diameter:
Type the diameter of the circle and press
ENTER.
Over Angle: (The value is from 1~360). After dispensing the circle, while going through
an extra part of the circle defined by the Over Angle, the dispenser will be
turned OFF.
Z Lift:
1. Yes
2. No
Selection:
If you want the Z-axis (tip) to lift while going through the Over Angle, you
must select 1. Otherwise: select 2.
The speed must be set in a previous memory address by registering a
Line
Speed
instruction using the
F4 (SETUP) KEY
.
Dispense delay times used at the start of the circle and at the end of the circle can be
controlled by registering a
Line Dispense Setup
instruction in a previous memory
address. The
Line Dispense Setup
instruction is registered by pressing the
F4
(SETUP)
key.
See also
.
The upward motion of the tip after dispensing can be controlled by registering a
Dispense
End Setup
instruction and / or a
Z Clearance
instruction in a previous memory address.
Dispense End Setup
and
Z Clearance
instructions are registered using the
F4
(SETUP)
key.
See also
.
Summary of Contents for F400N Series
Page 118: ......
