F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
43
© 2012 Fisnar Inc.
1.12
Brush Area
The Brush Area command causes the tip to „paint‟ a defined area.
There are six Brush Area types: Rectangle, Circle, Rectangle 1, Rectangle Band, Circle
Band and Circle1. The next pages provide a detailed description of all the Brush area
types.
To register a
Brush Area
command, follow the instructions below.
Instruction
Display Shows
1
Press
F1/ENTER
to open the Point Menu
[POINT] 1/3
1 Dispense Dot
2 Line Start
.
.
7 End Program
2
Press
X
, to go to page 2
[POINT] 2/3
.
.
4 Brush Area
.
3
Press
4
to select Brush Area.
Brush Area Setup
------------------
1.Rectangle
4.Rect Band
2.Circle 5.Circle Band
3.Rectangle 1 6. Circle 1
Select:
4
Press the numeric key corresponding to
the brush area type then press
ENTER
Brush Area Setup
------------------
1.Rectangle
4.Rect Band
2.Circle 5.Circle Band
3.Rectangle 1 6.Circle 1
Width(mm):
Band(mm):
5
Type the width value and press
ENTER.
Type the band value and press
ENTER.
Width and band values will be explained
further in this section.
Summary of Contents for F400N Series
Page 118: ......
