F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
46
© 2012 Fisnar Inc.
1.12.3
Brush Area: Rectangle 1
Brush Area Rectangle 1 causes the tip to „paint‟ the defined area by following a square
spiral path from the outside of the rectangle to the center.
After registering the Brush Area Rectangle 1 command, teach a Line Starting point at the
top left corner of the area to be brushed and a Line End point at the bottom right corner of
that area (the tip will not dispense a straight line between these two points):
If, for example, a brush width of 5 mm was used, the tip will take the following path when
the program is run:
Line Start
Line End
Paint
Area
5 mm
5
mm
Summary of Contents for F400N Series
Page 118: ......
