F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
47
© 2012 Fisnar Inc.
1.12.4
Brush Area: Rect. Band
Brush Area Rect. Band causes the tip to „paint‟ a defined rectangular band area by
following a square spiral path from the outside of the rectangle to the center.
After registering the Brush Area Rect. Band command, teach a Line Start point at the top
left corner of the area to be brushed and a Line End point at the bottom right corner of that
area (the tip will not dispense a straight line between these two points):
If, for example, a brush width of 5 mm and band of 10mm was used, the tip will take the
following path when the program is run:
Band 10mm
Width 5mm
Line Start
Line End
Summary of Contents for F400N Series
Page 118: ......
