F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
76
© 2012 Fisnar Inc.
The distance and speed that the tip raises after dispensing is controlled by the
L.Length
and
L.Speed
settings.
After the tip raises the length specified by
L.Length
at the speed specified by
L.Speed
,
the tip will continue rising to the
Z Clearance
height at the speed specified by
H.Speed
.
The purpose of specifying a Z Clearance height is to allow the tip to raise high enough to
clear any obstacles it may encounter on the way to the next point.
Values for
H.Speed
,
L.Speed
and
L. Length
are registered with the
Dispense End Setup
function by pressing the
F4 (Setup) key
, then choosing
Dispense End Setup
.
Once
Dispense End Setup
values have been registered at a memory address, all points
after that memory address will use the values specified. If
Dispense End Setup
values are
registered again, at a higher memory address, all points from that memory address
forward will use the new values.
Dispense End Setup
instruction.
H. Speed
2: Tip continues rising to
Z Clearance
height at
H. Speed
L. Length
1: After dispensing, the tip
rises to
L .Length
at
L. Speed
Z Clearance
Summary of Contents for F400N Series
Page 118: ......
