Sicherheitshinweise
51
D
GB
F
NL
I
E
P
GR
TR
RU
S
S
PL
CZ
ARA
12. Maintenance and replacement parts
Please note
Replace parts which are subject to wear, such as the rubber gasket and other rubber parts, regularly with original
Fissler spare parts after c. 400 cooking operations or at the latest after two years. Parts which are clearly damaged
(e.g. hardening, cracks, discolorations, overheating, or deformation) or do not fit properly must be replaced immedia-
tely. Failure to do so will result in the efficiency and safety of your pressure cooker being reduced.
Information on replacing parts
Silicone gasket
(Fig. A-20)
See Chapter 5.
Silicone membrane
(Fig. A-22)
See Fig. V
Detach the control valve from the lid and remove the old silicone membrane. Place the new silicone membrane on
the plastic rod of the traffic light indicator and press the edge onto the metal push rod as far as the beginning of the
thread.
Molded valve seal
(Fig. A-23)
See Fig. W
Detach the control valve from the lid and remove the old seal. Select Setting 2 on the control valve, because this will
make it easier to mount the seal. First place the new seal over the metal push rod, then press the other side all the
way up over the tappet. Ensure that the control valve seal is tight all the way round, and that the seal is contained in
the indentation provided for it.
Valve base seal
(Fig. A-24)
See Fig. X
Detach the control valve from the lid and remove the old seal. Put the new seal in place and make sure that the seal
is perfectly flat on both sides of the lid.
O-ring for Euromatic
(Fig. A-18)
See Fig. I
The o-ring is removed/mounted on the inside of the lid. Make sure that the ring lies totally in the groove provided
for it.
Euromatic
(Fig. A-18)
To remove/mount the Euromatic, you must first remove the lid handle. This is very simple, as you only have to loosen
the screw on the inside of the lid. You can remove the Euromatic from the lid as soon as you have removed the
o-ring. For mounting, guide the new Euromatic without the o-ring through the lid so that the side with the white ball
is on the inside of the lid. Then you can mount the o-ring as described above.
Maintenance and replacement parts
140902_02_GAL_Vitavit_premium_GB.indd 51
04.02.15 11:06
Summary of Contents for vitavit premium
