A5
A
E
H
H1
H2
Assembly for central support tube.
Step 1. Take off the bolt(A2), washer(A3) from the central tube(D) before assembly.
Step 2. Connected well th esensor wire(A9) and computer wire(A7).
Step 3. Assemble support tube(D) with the main frame(A) by bolts(A2) and washers(A3).
Assembly saddle support tube and saddle.
Step 1. Loosen the knob(A5) and keep on pulling it. Then, insert the saddle support tube(E)
into the main frame(A). Tighten the knob(A5) after the saddle support tube is equipped
appropriately. Attention: Please make sure the knob has been equipped exactly into the
adjusting hole of the saddle support tube(E).
Step 2. Put the saddle(H) on the top of saddle support tube€ and secure it nut, washer(H1,H2).
D
A3
A2
A
A7
A9
Handleiding Hometrainer Fit Bike Ride 2
