Fit4Home EK-EQXH-NEJX, User Manual

10

OPERATING THE COMPUTER

SPECIFICATIONS

: 

TIME……………………………………………………………………00:00-99:59

SPEED(SPD)..……………………………………………0.0-99.9KM/H (ML/H)

DISTANCE………………………………………………….....0.00-9999KM (ML)

CALORIES…………………………………………………….......0.0-9999KCAL

※ODOMETER(ODO)…………………………..…………..…0.0-9999KM (ML)

※PULSE (PUL) …….....................................................................0※40~240BPM

KEY FUNCTIONS:                                     

MODE: This key lets you to select and lock on to a particular function you want.

SET: Can to proceed the data establish for “TIME” “DISTANCE” “CALORIES”“PULSE”.

CLEAR(RESET): The key to reset the value to zero by pressing the key.

ON/OFF(START/STOP): The key to pause the signal input by pressing the key.

OPERATION PROCEDURES:

1. AUTO ON/OFF

•   The system turns on when any key is pressed or when it sensor an input from the speed sensor.

•   The system turns off automatically when the speed has no signal input or no key are pressed for 

approximately 4 minutes.

2. RESET

The unit can be reset by either changing battery or pressing the MODE key for 3 seconds.

3. MODE

To choose the SCAN or LOCK if you do not want the scan mode, press the MODE key when the pointer on the 

function you want which begins blinking.

FUNCTIONS:

1. TIME: Press the MODE key until pointer lock on to TIME. The total working time will be shown when starting 

exercise.                                                                       

2.SPEED:Press the MODE key until the pointer advance to SPEED. The current speed will be shown.

3.DISTANCE:Press the MODE key until the pointer advance to DISTANCE. The distance of each workout will be 

displayed.

4.CALORIE: Press the MODE key until pointer lock on to CALORIE. The calorie burned will be displayed when starting 

exercise.

5.ODOMETER(IF HAVE): Press the MODE key until the pointer advance to ODOMETER.The total accumulated 

distance will be shown.

6.PULSE(IF HAVE): Press the MODE key until the pointer advance to PULSE .User’s current heart rate will be 

displayed in beats per minute. Place the palms of your hands on both of the contact pads(or put ear-clip to ear),and 

wait for 30 seconds for the most accurate reading.

7.SCAN: Automatically display changes every 4 seconds. 

8.BATTERY:If improper display on monitor, please reinstall the batteries to have a good result

HOW TO INSTALL THE BATTERY:

1.  Remove the battery cover at the rear of computer.

2.  Place two “SIZE-AA” battery into the battery housing.

3.  Insure battery is correctly positioned and battery spring is proper contact with battery.

4.  Re-install the battery cover.

5.  If the display is illegible or only partial segment appear, remove battery and wait 15

6.  seconds before reinstalling.