51
ELECTRIC TREADMILL
MC-460
EN
TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem
Cause
Solution
The display shows "E01"
Incorrectly connected signal cable
Reconnect the signal cable
Broken signal cable
Change the signal cable
The display shows "E02"
Current overload
Turn off the machine and restart
Burned engine
Change the engine
Burned PCBs
Change the new PCB unit
Input voltage too low
Check the input voltage
The display shows "E03"
Protection overload
Turn off the machine, let it rest and restart.
The display shows "E04"
High current surge protection
Turn off the machine and restart
Burned PCBs
Replace the printed circuit board
The display shows "E05"
Explosion protection
Check the input voltage
Burned PCBs
Change the new printed circuit board
The motor cable is not connected
properly
Reconnect the motor cable
The display shows "E06"
Problem with the motor cable
Reconnect the motor cable or replace it
STORAGE AND TRANSPORT
FOLDING AND TRANSPORTING
Unlock the console lock knob and set the vertical column to position 1, release the knob and drop the column to
position 2.
To transport the belt place the belt in vertical position, as shown in the picture, peel off the wheels by pressing in the
direction (A) and when holding itself (B), release your hands.
STORAGE
Store equipment in a clean, dry, indoor location. Never leave or use the unit outdoors. Make sure the main power switch
is turned off and the power cord is disconnected from the wall outlet.
2
1
B
A
Summary of Contents for 1100032
Page 67: ......
Page 68: ...Manual revisado en octubre de 2020 www fitfiu es...