12
Assembly is now complete.
IMPORTANT:
Please read pages 15-17 before beginning your workout for
important instructions on how to use your elliptical trainer.
STEP 11– Adjusting the Level of the Elliptical Trainer
NOTE: If unit is not level please follow instructions below.
The Levelers are located on the bottom right and left side of the unit. You can use the 17mm Open
End Wrench provided to adjust. The Levelers on your unit are set at the lowest position.
• To raise the Levelers, turn the Levelers to the left. When you reach the desired height, turn the
M10 Hex Nut to the right until tight.
• To lower the Levelers loosen the M10 Hex Nut by turning to the left until the Nut is snug to the
Leveler. Turn the Leveler to the right until you reach the desired height. Tighten the M10 Hex
Nut by turning to the right until tight.
• Make sure the elliptical trainer is level before exercising.
11
levelers
(located on both sides of unit)
leveler
M10
hex nut
Summary of Contents for 1400
Page 15: ...14 EDGE 1400 EXPLODED VIEW ...