FIGURE 5
ASSEMBLY
FIGURE 5
Step 11. Remove the four BUTTON HEAD SCREWS (20) and M8 WASHERS (4) from the FRAME (3).
Step 12. Plug EXTENSION WIRE (17) into REED SWITCH WIRE (18). Secure connection with tape.
Step 13.
NOTE:
Turn TENSION KNOB to position 8 before connecting TENSION CABLE to
TENSION BLOCK (19).
Push EYE of TENSION CABLE into WIRE LOCK of TENSION BLOCK - see DETAIL.
Step 14. Pull TENSION CABLE through SLOT and place CABLE HOUSING on top of TENSION BLOCK
(19) - see DETAIL.
Make sure the EXTENSION WIRE (17) is through the top of the CONSOLE TUBE (16) and slide
CONSOLE TUBE over the FRAME (3). Fasten with hardware removed in Step 11.
NOTE: DO NOT
pinch wires while attaching CONSOLE TUBE.
NOTE:
You may need
two
people to complete the following steps. One to hold CONSOLE TUBE (16) while
attachments are made.
20
BUTTON
HEAD
SCREW
17
EXTENSION
WIRE
18
REED
SWITCH
WIRE
20
BUTTON
HEAD
SCREW
3
FRAME
16
CONSOLE
TUBE
TENSION
CABLE
19
TENSION
BLOCK
TENSION
KNOB
CABLE
HOUSING
DETAIL
TENSION
CABLE
EYE
19
TENSION
BLOCK
SLOT
WIRE
LOCK
4
M8
WASHER
7
17
EXTENSION
WIRE
Summary of Contents for Edge 386da
Page 1: ... Model 386da Dual Action Magnetic Bike ...
Page 17: ...17 FIGURE 13 ...