EN
EN
8
9
Introduction
Thank you for choosing the FitWood KUMPU Montessori bookshelf. Please read this manual carefully
before installation and follow each step closely to ensure the safe use of the product.
Keep this manual for future reference. If you need assistance with installation, please get in touch
with us directly.
FitWood Oy
Hautalankatu 20
33560 Tampere
Suomi
info@fitwood.com
Disclaimer
Read all instructions and follow assembly instructions carefully before using the product.
FitWood shall not be responsible for injury or damage caused by neglect of instructions contained in
this manual or FitWood’s website, incorrectly following instructions, or misuse of the product.
The warranty covers only defects in the product, in which case the defective product or its parts
are primarily replaced with a new one. The warranty does not cover damage caused by misuse,
adverse conditions for product materials, or natural wear and tear. FitWood shall never be responsible
for consequential damages arising from the use of the product, defective or broken product, and
FitWood’s liability is limited to repairing or replacing the faulty product.
Recommended tools
• Drill or screwdriver and Torx TX25 tip.
• Hammer
Make sure you have the following parts
Assembly instructions
Always screw the screws slowly. The material is wood and can split with excessive force. When all
the screws are in place, check that they are correctly tightened.
- Assembly of this product requires two people.
- Assemble the bookshelf on a soft surface, such as cardboard or a carpet.
- Remove all packaging material before assembly.
- Arrange all parts in advance and make sure you have all the necessary parts
Boards and their positions
The product includes five different kinds of straight boards. Follow the assembly instructions carefully
to ensure the boards are properly inserted and placed in their correct positions.
Note! Only some of the boards have rounded edges. To ensure the safe use of the product, it is
important to insert rounded edges in their correct positions.
1. Front board (small, rounded edges)
2. Shelf board (one large, rounded edge, screw-mounted)
3. Backboard (small, rounded edges on the other side)
4. Table top (small rounded edges on the other side, screw-mounted)
5. Seat board (board has a logo, all edges are rounded, screw-mounted)
ROUNDED EDGES
ROUNDED EDGE
ROUNDED EDGES
