Installation Instructions
005720D Rev D
Page 18 of 20
Series 7 AdjusTables
w
w
w
.
d
e
t
a
i
l
s
-
w
o
r
k
t
o
o
l
s
.
c
o
m
FitWork
™
Sit-to-Walkstation
Pull console forward.
11
Connect safety key to magnetic
attachment area on
front of keypad.
12
GLIDE
Before use, the table must be completely leveled, front-to back and side-to-side.
Coordinating the Lifting Columns
Prior to initial use of the height adjustment function you must "synchronize the system".
The installers who setup the worksurface may have already done so, but it's OK to repeat this function.
Synchronize the System
• Press the Down arrow until the worksurface comes to a stop at the lowest position.
• Release the Down arrow.
• Press and hold the down arrow for approximately 5 seconds while the table
synchronizes itself. The surface will lower itself approximately 5mm, then rise
approximately 5mm and finally settle back to its lowest position.
NOTE:
It may be necessary to repeat the synchronization process more than once.
After performing this function, the movement of all lift columns connected is coordinated.
In the unlikely event that an error occurs, reset the control unit by pressing the Up and
Down buttons at the same time for 5 seconds. Then repeat the synchronizing sequence
as previously outlined above.
13
14
Raise or lower desk height
by pressing buttons on the
console.
NOTE:
Guidelines on Moving the Table, see page 19.
For Wiring Guide, see page 20.
