Five9 Network Systems LLC.
X2000 Installation Manual
Document # 000001, Rev III, 03/2012
Page 6
Length of cable runs
Environmental conditions
Access for service repair (if applicable)
Note: Please see detailed instructions for rack mounting in section 3.1.3
3.1.2 The X2000 shall be installed to conform to the standards designated by
the customer and manufacturer specifications as to the unit location and
type of installation
3.1.3 The following rack mount instructions should be followed
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment
may be greater than room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be
such that the amount of air flow required for safe operation of the
equipment is not compromised.
C) Mechanical Loading - Mounting of the equipment in the rack should be
such that a hazardous condition is not achieved due to uneven
mechanical loading.
D) Circuit Overloading - Consideration should be given to the connection
of the equipment to the supply circuit and the effect that overloading of
the circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be
used when addressing this concern.
E) Reliable Earthing - Reliable earthing of rack-mounted equipment
should be maintained. Particular attention should be given to supply
