STEP 6
ASSEMBLE SURFACE BURNER COMPONENTS
•
Remove shipping screw from each surface burner.
•
Remove each surface burner.
•
Place drip pan in position under each burner. Locate “dimples”.
•
Re-install surface burners.
•
Install burner pans.
•
Install burner grates.
STEP 7
GAS & ELECTRIC SUPPLY
•
Turn gas supply “on”.
•
Turn electric supply “on”.
STEP 8
SURFACE BURNER OPERATION
OPEN SURFACE BURNERS
•
Check for proper ignition:
−
Push in one control knob and turn 180° counter clock-
wise to LITE position.
−
The igniter will spark and the burner will light; the
igniter will continue sparking until the knob is turned
from the light position.
−
First test may require some time, while air is flushed
out of the gas line.
−
Turn knob to OFF.
−
Repeat the procedure for each burner.
•
Burner flames should be blue and stable with no
yellow or yellow tips, excessive noise or lifting of the
flame from the burner. If any of these conditions exist,
check that the burner ports are not blocked, and check
the air mixture. If one of these conditions continues,
call for service.
