Fixpoint AP 2, Manual

11

3 Notes on Safety:

   ATTENTION! Only skilled electricians may assemble and disassemble the  

  housing  of the product. There is a risk of electric shock, short circuit and  

 burning!

•   Your product is not a toy and is not meant for children, because it contains small parts   

  which can be swallowed and injured when used inappropriately!

•  Warning: this tool must be placed on its stand when not in use. 

•  This appliance is not intended for use by persons (including children) with reduced 

  physical, sensory or mental capabilities, or lack of experien ce and knowledge, unless 

  they have been given supervision or instruction concerning use of the appliance by a 

  person responsible for their safety. 

•  Children should be supervised to ensure that they do not play with the appliance. 

•   If the supply cord is damaged, it must be replaced by the manufacture, its service agent 

  or similar qualified persons in order to avoid a hazard 

•   Please install and store the product and its accessories in a way persons cannot be   

  injured, or objects not be  damaged for example by dropping or stumbling.

•   Please remove or store the packing materials well, because children may cut themsel-  

  ves on them  while playing. Furthermore, there is a risk of swallowing and inhalating of   

  incidentals and insulating material.

•  By using in schools the soldering station must be supervised by a teacher.

•  The soldering station may only be used in case of an assured operation. In the  

  following cases you CANNOT expect an assured operation:

  - visible damages (e.g. faults of isolation, damage of the housing)

  - no function

  - long storing under bad conditions

  - improper transport

•  A defective soldering station may not be put into operation, but must be disconnected    

  from mains and protected against further use. Repairing, such as assembling and  

  disassembling the housing is only allowed to skilled professionals. By repairing it  

  yourself you will loose all warranties and there is a risk of electric shock, short circuit    

  and burnings.

•  Drive the product only with 220 - 240 V ~ / 50 Hz a.c. networks.

•   Unplug the mains cable when not in use and during thunder storms.

•   Avoid places with high humidity, or places which might come into contact with water.

•  Do not use the device next to flammable material or gases.

•  Only work in well ventilated rooms or under applicable exhaust hoods, because  

  soldering smoke is harmful.

•  Soldering work may only be done with current- and voltagefree parts.

•  Mind and follow the terms of law and health care for using the device in industry.

•  The soldering iron reaches temperatures of more than 160°C. Touching the heated  

  metal parts can cause fatal burning insuries to people and animals.

•  Swich off the soldering station during longer working breakes.

•  Never dunk soldering iron or soldering station into water for cooling!

•  Never expose the product to high mechanical pressure.

•  The soldering station heats up very much during operating. So only place it on solid,    

  fixed and fire resistant bases.

•   Do not modify or change the product or its accessories! Also mind chapter “warranty