Fixturlaser NXA Pro
1. Rough Alignment
• Vertical: Place scale or straightedge on highest hub and
raise or lower the movable shaft to within 0,5 mm of the
stationary hub.
• Horizontal: Place scale or straightedge on hub nearest to
you and adjust the movable shaft to within 0,5 mm
of the stationary hub.
2. Correct Obvious Soft Foot
Loosen all the bolts and find any obviously loose shim packs.
Add shims as needed to make a snug fit.
3. Follow Tightening Sequence
Follow the same sequence throughout the alignment
process, and tighten in 3 passes: snug first, 50% on second
pass, completely tight on the third pass. (View sequence on
next page)
P R E - A L I G N M E N T
