Airplane Manual FK 9 ELA
FK Lightplanes
Revision 7
Handling, Serv.& Maint.
page 8-8
Cover the gap between wing and fuselage with tape for better
aerodynamics
Secure all bolts
Install the other wing in the same manner
The storing device at the aft fuselage can be removed now
Mount the outer parts of the elevator
Connect and secure the rods for ailerons
Connect the pitot tube line
Install the doors
Install the strut covers (if available)
Check the function of all flight controls and flaps
To disassemble the aircraft follow above mentioned steps in reverse order,
observe the following steps.
If required, remove the elevator tips
install the storing device for the wings at the aft part of the fuselage
Note: the screws at the main tube of the folding mechanism (overhead
the pilots) are the stop for the folding mechanism; they must only be
removed it is intended to remove the wings completely from the fuselage
to fold the wing:
pull the wing outside until the stop, turn it 90° (the leading edge facing to
the ground), now fold it and store it into the device