Vertical Wrap Installation
flair21.com | 800.845.0918
CAUTION!
• PVC vanes should be stored on a flat, level surface until they are installed.
• Your Vertical Wrap fabric was carefully inspected for holes, snags, runs and other flaws prior to shipping. Please use extra caution
when installing the wrap onto the vertical system.
flair21 will not be held responsible for damage to the fabric caused by
installation or rough handling of the fabric.
• The child-safety tension device must be properly and securely mounted with tension on the drive loop for the system to be fully operable.
PACKING LIST
1. Headrail with Bead Chain and Cord
2. Wall Brackets
3. Mounting Clips
4. Child-Safe Tension Device
5. PVC Vanes
6. Valance
7. Valance Returns
8. Valance Clips
9. Valance Return Connectors
3
1
4
2
5
7
8
6
9
Step 7
ATTACH SNAP TAPE
Slip the snapped portion of the snap
tape over the front of each vane, then
slide the snap tape around the other
side of the carrier and snap the tape at
the back of each vane.
Step 8
INSERT BOTTOM OF VANES
Carefully slide each vane in front of the tack
at the bottom of the wrap.
TIP: To prevent snagging the fabric, wrap
a plastic sandwich or grocery bag around
the vane while sliding it in front of the tack.
Ceiling or
Window Well
Valance
Valance Clip
Step 9
OUTSIDE MOUNT VALANCE
Snap the mounting clips
(that are attached to the
valance clips) onto the
top of the headrail. Attach
the valance to the valance
returns using the valance
return connectors, then snap
the completed valance onto
the valance clips.
FOR SHIRRED SLEEVE VALANCE: Shirr the sleeve onto the PVC valance. Attach the returns to the valance using the valance return
connectors. Shirr the sleeve over the returns and use the provided clips to secure the fabric. Connect the valance clips (over the fabric)
onto the valance, and connect the completed valance onto the headrail.
Step 9
INSIDE MOUNT VALANCE
Instal the mounting screw
through the headrail bracket
clip and valance clip as shown
(see Step 1). Attach the valance
to the returns using the valance
return connectors, then snap the
completed valance (with returns)
onto the valance clips. Make sure
the vanes do not hit the valance.