Commissioning
HyPower-Geko
100
FläktGroup DC-2014-0022-GB 2018-05/R5 • Subject to modifications
7.3
Vent the unit
To ensure that the exchanger is charged with heating/cooling medium, it must be air
vented.
7.4
Checking the condensate drain
This checkpoint only applies to cooling units without condensate pump!
Condensate forms as a result of unit operation in cooling mode, the same applies to
non-insulated pipes. Check
•
that the connection of the condensate tray (fig. 7-7, Pos. 1) is performed so that
condensate can drain freely. At the same time a sufficient slope of the condensate
line must be considered.
User instructions!
Protect electrical hardware and furniture from escaping splash water.
•
Open all shut-off and control valves.
•
Open the venting screw(s) with a suitable tool
(see fig. 7-6).
•
Close the air vent screw again only if heating/
cooling medium is still pouring out.
•
Proceed in the same way with all remaining air
vent screws. Depending on the unit model,
there are additional 1 or 2 air vent screws.
Pos. 1:
Air vent screws
Fig. 7-6:
Air venting heat exchanger
Pos. 1:
Coil drip tray
Pos. 2:
Condensate drain
Fig. 7-7:
Drainage of the condenser water