HyPower-Geko
Electrical connection
FläktGroup DC-2014-0022-GB 2018-05/R5 • Subject to modifications
71
Group structure of the MATRIX 3000 system in combination with the MATRIX 2000 system
A group may be formed using the MATRIX 2000 and MATRIX 3000 systems. The
fig. 6-27 shows an example of a network consisting of a control panel, MATRIX 2000
system, MATRIX 3000 system and various global modules.
Fig. 6-27: Combined group structure of controller types MATRIX 2000 and MATRIX 3000
The group address is assigned:
– via the group address switch on the control panel – refer to the “Commissioning and
Testing” section in the relevant operation manual for FläktGroup MATRIX control
panels
– on the printed circuit board of the MATRIX 3000 controller – refer to the unit’s oper-
ation manual.
Data assignment of MATRIX.LON module is performed via LON-side configuration.
The MATRIX.V module is assigned to this group via the group address switch – refer
to the “Commissioning” section in this operation manual or the corresponding manual
for MATRIX Global Modules.
Units 2 to 16 can be freely assigned.
The control panel must be connected to a MATRIX 3000 controller type
The MATRIX 3000 system permits the installation of a group, also with components
from the MATRIX 2000 system.
Besides, the control panel is not required if global modules such as MATRIX.LON, DI,
DO, AI are installed, and the required operating parameters and setpoints are commu-
nicated via these group modules.
Unit 1
Unit 2
Unit 16
Max.
Group
4-7 wires
4-7 wires
4-7 wires
4-7 wires
Unit 16
Unit 2
Unit 16
1 control panel
Network