LIGHT BULB MAINTENANCE
1. To inspect or replace the bulb(s), first unplug the power cord from the outlet.
2. Locate the Access Panel on the bottom of the fireplace. Remove the screws and the panel.
3. Check the bulb to see if it is loose. Bulb should be finger tight.
DO NOT
over-tighten.
4. Replace any damaged or faulty bulb -
one spare bulb(E)
has been included for your convenience.
5. Reattach the access panel.
•
DO NOT
operate this heater without the Access Panel in place.
•
DO NOT
remove the back cover. There are no user-serviceable parts inside.
The flame effect is created by 1 x 40-Watt light bulbs with E-12 (small) socket base. Use only this same
type of bulb as a replacement. If the flame effect does not work, the bulbs may have come loose or
been damaged during shipping.
3
11
ALWAYS
turn the heater
OFF
and
unplug the power cord from the outlet
before cleaning,
changing the light bulbs, or moving this unit. Failure to do so could result in
electric
shock
,
fire
, or
personal injury
.
WARNING
Light bulbs become very hot during use. Allow at least 10 minutes for the
bulb(s) to cool before touching.
Access Panel
