OPERATION
POWER
METHODS OF OPERATION
TEMPERATURE LIMITING CONTROL - AUTO SHUT OFF
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature (239°F / 115°C), the heater will automatically turn OFF.
Front View
Back View
Top View
Left Side View
6
6
Read and understand
this entire owner’s manual, including
all safety information
,
before
plugging in or using this product. Failure to do so could result in
electric shock
,
fire
,
serious
injury
, or
death
.
NOTICE
This heater is not intended to be a primary heat source. It is designed to provide
supplemental heat, and should not be left running to continuously for more than
eight hours.
TO RESET
This heater can be operated by the CONTROL PANEL, located on the front panel of the heater, or by
the battery-powered REMOTE CONTROL. Before operating, please review the
IMPORTANT SAFETY
INFORMATION on Page 2 and 3
, and follow all warnings.
Make sure the POWER switch, located on the front panel, is turned
OFF
. Plug the power cord into
a 120 Volt 15 Amp grounded outlet (see
IMPORTANT SAFETY INFORMATION on Pages 2 and 3
).
Make sure the outlet is in good condition and that the plug is not loose.
NEVER
exceed the maximum
amperage for the circuit.
DO NOT
plug other appliances into the same circuit.
Turn
OFF
the POWER switch on the CONTROL PANEL. Unplug the power cord from the outlet.
Wait 15 minutes.
Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint.
If they are, use a vacuum to clean the vent areas. With the POWER switch turned
OFF
, plug the power
cord back into the outlet and turn the POWER switch
ON
. If the heater switches off again,
UNPLUG
THE HEATER RIGHT AWAY!
Have the outlets, wiring and breaker box inspected by a professional.
Make necessary repairs before using the heater again.
比例
25.400
比例
