CONTROL PANEL FUNCTIONS
3
7
NOTICE
When this heat function is used for the first time, a slight odor may be present.
This is normal and should not occur again unless the heater is not used for an
extended period of time.
½
CONTROLS
FUNCTION
Power
Press once
to turn the power
ON.
Press again to
turn the power
OFF.
Power Indicator
When power is
ON
, red light will glow.
Flame +/-
Press Flame (+/-) Button
to desired flame
brightness
.
6 options.
Timer +/-
Press Timer (+) once to increase timer setting
by
hour increments. Maximum timer setting is 7½ hours.
Indicator light will illuminate.
Press Timer (-) once to decrease timer setting
by ½
hour increments.
Heater
Press the Heat Button once
,
750W (LOW HEAT)
heater turns on and the fan starts to blow warm air.
Press the Heat Button again
,
1,500W (HIGH HEAT)
heater turns on and blows hot air.
Press the Heat Button again
and heater turns
OFF
.
The fan will continue to blow to allow heater to cool
down, and then turns off.
Thermostat
Control
Heater must be ON either LOW or HIGH heat for the
thermostat function to operate
. The heat output is
controlled by the
Thermostat Control
. Set the
Thermostat Control
to the maximum position initially.
When the room reaches the desired temperature,
reduce the setting by slowly turning the thermostat knob
counterclockwise until the heater will click and turn off.
The heater will then maintain the room temperature at
the desired level.
POWER
TIMER
FLAME
-
-
+
+
HEATER
1/2h
1h
2h
4h
1
2
3
4
5
6
7
8
9
Thermostat
