23
|
Page
FIREPLACE TELESCOPIC LEGS SETUP
The fireplace legs will need to be set up once box is removed. The legs can be configured so that the bottom of the
glass will be between 10”
-
19” above the floor. This means the bottom of the fireplace will be 4”
-
13” above the floor.
Follow the steps below for telescopic legs setup prior to final positioning of the fireplace.
On Corner units (Flare-RC/LC/DC/RD) front legs will need to be assembled.
Fireplace must NOT be installed without telescopic legs extracted to a minimum of 3”.
Installing fireplace without telescopic legs is a fire hazard.
Installing the Fireplace without legs (sitting on the fireplace frame) may bend the frame & cause glass breakage.
Fine Tuning
After extending the legs to the desired length, use
the wrench included to fine tune the feet so that
the fireplace is level.
Note
that the feet are intended for minimal
adjustments and not to be extended completely for
extra height. Doing so will make the fireplace
unstable.
The feet are used for fine tuning & should
only be adjusted once the fireplace is standing.
Opening or extending the legs too much will
cause the fireplace to become unstable
