www.flash-butrym.pl
Strona 2
Thank you
for choosing one of our DMX splitters. Please read this user manual
carefully and follow the instructions to avoid danger or damage to the unit due to
mishandling. Keep this user guide for future reference.
1. Safety Instructions
Please carefully read the instruction, which includes important information about the
installation, usage and maintenance, BEFORE operating this device.
*This device is exclusively meant to be used as a splitter for DMX signals within the
limits given in this manual. Using it in any other way you risk electric shock and
warranty will become void.
*Never sever or manipulate the power cord or the plug. If a power cord is provided
with an earth lead, this is mandatory to ensure safe operation! Otherwise a
LIFE
THREATENING
situation exists!
*Unpack and check carefully there is no transportation damage before using the unit.
Never put a damaged device into operation.
*Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit as stated in this manual.
*The unit is for indoor use only. Use it only in a dry location. Exposing the device to
rain or moisture would cause the risk of electrical shock or fire.
*DO NOT let any liquids or objects enter the unit. Should any liquid be spilled on the
unit, DISCONNECT the power supply to the unit immediately and contact the
service company.
*The unit must only be installed in a location with adequate ventilation. Be sure that
no ventilation slots are blocked. In order to guarantee adequate ventilation, allow a
free air space of at least 20 cm around the sides and top of the unit.
*Disconnect the device from the mains power before any servicing or maintenance.
Notice regarding power disconnection: To disconnect the device from the power
source the power plug must be removed from the power socket. For this reason the
device must be placed in a position where a constant unobstructed access to the
power socket is assured, thus in an emergency situation you are able to immediately
pull out the power plug. To eliminate the risk of fire you must completely disconnect
the power plug from the power socket after the device has been used.
*Always grasp the power cord by the plug. Do not pull on the cord itself and never
touch the power cord with wet hands as this could result in a short circuit or an
electrical shock. Do not place the device, speaker cabinets or anything else on the
power cord and make sure that it does not become clamped.
2. Introduction
The DMX distributor offers one input and eight outputs. Both inputs and outputs as well as
outputs among each other are completely eclectically isolated. Each DMX output features an
independent driver and DATA+ & DATA- indicator. Using the built-in switch you can easily
terminate the LINK OUT, when you don’t want to transmit the DMX signal to other units.
