www.flash-butrym.pl
Strona 3
3. Technical Specyfications
Power supply voltage : AC 90-230 V~, 50 Hz
Fuse (internal) F 500 mA, 250 V
4. Operating instruction and connection
You can run a maximum of 32 units (receiver) per output channel.
Use a terminator on the last receiver.
If you don’t connect other units to the DMX LINK OUT socket, you have to press the
switch underneath the socket, to terminate this output.
You may only connect the device to a properly wired and earthed mains power
wall outlet, after all DMX connections have been established. The wall outlet
must provide the correct mains voltage as stated in this manual.
DMX OUT: connect the DMX receiving device(s) here
DMX IN: connect the DMX transmitting device here
This is the unit’s pin assignment:
Pin 1: Ground/Shielding
Pin 2: Data –
Pin 3: Data +
