Flash-e-Vapor V4.5/V4.5L
—
Instruction
manual
english
3
The Flash-e-Vapor V4.5/V4.5L is a rebuildable atomizer, which has been
designed exclusively for the use with e-liquids.
Before use, it is necessary to wind a coil from suitable resistance wire
(e.g. Kanthal A or NiCr heating wire as well as a suitable wick
( Ortmann-Schnur, organic cotton (e.g. muji), silicate fiber) and to attach it
according to the instruction manual (p.6) .
For the liquid supply from the tank, you must attach two wicks from the
included cotton cord and cut them according to the instruction manual
(p.7).
Once a new coil has been attached, it is important to measure the
resistance of the coil, which should be between 1.0 — 2.5 Ohm. For this
purpose use a multimeter, a suitable battery mount with resistance
measurement or an especially designed resistance meter from a specialist
store for e-vaporizers.
Should you detect a short circuit, do not operate the evaporator under any
circumstances. Short circuits may damage the battery mounts and/or
batteries. Correct the coil in this case or create a new coil!
IMPORTANT!
Use only liquids (e-Liquids) that are intended exclusively for the use in
e-cigarettes.
IMPORTANT!
Use only suitable battery mounts from specialist e-evaporator stores for your
Flash-e-Vapor V4.5/V4.5L.
You should use only electronically controlled devices.
