www.flash-butrym.pl
4
5.2
Voltage specification
Input Voltage
Total Power
Frequency
95~240V
65W
50/60Hz
5.3
Connecting power supply
The connection is performed using power cable with IEC C13 connector (included).
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
CAUTION!
In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
6
OPERATION MANUAL
6.1
Control panel
The control panel is equipped with display and 4 control buttons:
1.
MENU – access to menu
2.
DOWN – change value, go to next option
3.
UP – change value, go to previous option
4.
ENTER – confirm changes
6.2
Menu
Menu diagram:
DMX channel
Addr
→
001 - 512
Channel mode
Chnd
→
10CH, 12CH, 15CH
Master / slave mode
Slnd
→
Master, Slave 1, Slave 2
Show mode
Shnd
→
Show 1-4
Auto-run mode
Auto
→
Non-automatic, automatic
Sound control
Soud
→
On-Off
Sound sensitivity
Soen
→
00-100
Pause mode
Blac
→
Stop, Start up
Backlight
Led
→
On-Off
Display flip
Disp
→
disp-disp
X axis flip
Pan
→
Yes-No
Y axis flip
Tilt
→
Yes-No
Menu test
Menu
→
Pan, Tilt, Zoom, Red, Green, Blue, White, Dimmer, Strobe
Automatic test
Test
→
Test
Reset
Rest
→
Reset
