Please keep this User Manual for future
consultation. If you sell the fixture to another
user, be sure that they also receive this
instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
fixture.
Before operating, ensure that the voltage
and frequency of power supply match the
power requirements of the fixture.
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
Use safety chain when fixes this fixture.
Don’t handle the fixture by taking its head only,
but always by taking its base.
W A R N I N G !
The Led Moving Head (LMH) has a powerful pan motor. The torque reaction when
the head is panned suddenly can cause the base to move if the fixture is standing unsecured on
a surface. Do not apply power to the LMH unless the baase is securely fastened to a surface or to
rigging hardware.
W A R N I N G !
Use 2 clamps to rig the fixture. Do not hang the fixture from only one clamp. Lock
each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full 90
0
clockwise.
W A R N I N G !
When clamping the fixture to a truss or other structure at any other angle than with
the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not use any type of
clamp that does not completely encircle the structure when fastened.
W A R N I N G !
Position or shade the head so that the front lens will not be exposed to sunlight or any
other strong light source from any angle - even for a few seconds.
S e e F i g u r e 1
. The LMH lens
can focused the sun's rays, creating a potential fire hazard and causing damage.
I M P O R T A N T !
Do not point strong light output from other fixtures at the LMH, as intense
illumination can damaged the display.
Maximum ambient temperature is: 40°C
Don’t operate it where the temperature is
higher than this.
In the event of serious operating problem,
stop using the fixture immediately. Never
try to repair the fixture by yourself. Repairs
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation and
there might be a hazard of electric shock.
To prevent or reduce the risk of electrical
shock or fire, do not expose the fixture to rain
or moisture.
The housing must be replaced if they are
visibly damaged.
Do not look directly at the LED light spot
while the fixture is on.
2. SAFETY INFORMATION
1. INTRODUCTION
THANK YOU FOR PURCHASING
LED MOVING HEAD 7X40W BIG EYE MINI
. FOR SAFETY
REASONS AND TO ENSURE THE TROUBLE-FREE OPERATION, CAREFULLY READ THE
INSTRUCTIONS.
User Manual • Instrukcja Obsługi
Figure 1.
Lenses can focused sunlight and strong light, presenting a risk of fire and damage to the fixture.
Shield or shade the head if necessary.
WARNING
Summary of Contents for 7X40W BIG EYE PRO
Page 18: ...User Manual Instrukcja Obsługi ...
Page 19: ...7X40W BIG EYE PRO Art No F7100555 ...
Page 20: ...www flash butrym pl F7100554 ...
