www.flash-butrym.pl
Strona
11
ATTENTION
：
：
：
：
DANGER OF LIFE
！
！
！
！
RISKOF FIRE
！
！
！
！
RISK OF SHORT CIRCUIT
！
！
！
！
ATTENTION
：
：
：
：
DANGER OF LIFE
！
！
！
！
RISKOF FIRE
！
！
！
！
RISK OF SHORT CIRCUIT
！
！
！
！
ATTENTION
：
：
：
：
RISK OF SHORT CIRCUIT
！
！
！
！
The producct must only be connected to a proper outlet of the public supply grid .Connect the mains cord to suitable
outlets only ! Use entensions cords in compliance with specifications only! Do not allow the mains cord to come into
contact with other cords!
Ensure during instaltation ,operation,transport and storage that none of the cables are freely exsposed!
Never touch the mains cord ,mains plug and outlet with wet or damp hands !
When not using the product, and prfor to cleaning always disconnect the product from mains! To do so, hold the
mains plug by the handling surface and never pull the mains cord!
Never connect the device to dimmer packe!
3. Housing
Always ansure during installation,operation,transport and when storing the product that no shocks or other forces
impact the housing !
The housing must not touch onto any other devices or objects during operation!
Easily flammable materials,e.g. decoration material and other surfaces and objects,must maintain a minimum
distance of 3m to the housing !Walls must maintain a minimum distance of 50cm to the housing!The device must be
installed on a fireproof surface only (no carpet)1 Always ensure aproper circulation of air.
Do not touch the housing during operation it will heat up .The housing is safe to touch approx .5 minutes following
the end of operation!
The device must never be carried via the projector anns.Use the carring handles only !
Fluids must not enter the housing as this could reduce the protective insulation and may trigger short cirouits which
may lead to fatal electrio shocks !If flulds have entered, disconnect the mains plug immediately and secure the
product against unintentional operation and contact yours specialized dealer! Damage caused as a resuit of fluids
entering the housing is exempt from warranty .
No metal parts or other items must enter the housing as this may reduce the protective insulation or trigger short
circuits which may lead to fatal electric shocks !If metal parts or other items have entered ,disconnect the mains plug
immediately,secure the product against unintentional operation and contact your specialized dealer!Damage caused
by metal parts or other items in the housing is exempt fromwarrantly.
4. Operating Environment
The product must be operated and stored in a dry environment only !Splash water ,rain,humidlty,fog may reduce the
protective insulation which may lead to fatal electric shocks!The limlt value for relactive humldity is 50% at 45
℃
.A
minimum distance of 1.5m to a fog machine must be observed ;fog saturation in the room must not reduce the
vislbllity to below 10m .
The product must be operated at a temperature range of between -5
℃
and 45
℃
only.Protect the product against
direct exposure to sulight or other heat,such as from rediators! If the produc is taken from a cold environment into a
warm environment it must only be taken into operation once it has reached ambient temperature,since the
condensation created by the difference in temperature may destroy the device!
Protect the product against dus!Dust may reduce the protective insulation,which may cause fatal electric shocks!
The product must be operated at altitudes ranging beween 20m below and 3000m above sea level only!
The product must not be operated during thunder storms;risk of destruction from surge voltages!
The product must be operated at a minimum distance of 1.5m to lit objects only!
5. Installation
This product can be operated suspended or as stand-alone system.
Should your lighting effect show any signs of damage,do not install the device!In this case,have your lighting effect
repaired by your specialized dealer.The manufacturer does not accept responsibility or liability for damage to
property or personal injury resulting from an improperly installation!
As a stand-alone system the device must be installed vertically on an absolute planar,firm,fireproof,shock-
