ENTER End
*/
$
%
ENT
*
*
ZEND
*
108
(A) Scan “Enter” barcode
(B) Scan “LED Off Delay” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 0.1sec, the
parameter value is
0.1 sec / 0.01 sec
= 10
Note: this configuration is only applicable when the scanner is in USB
cable mode.
7-8 Lamp Off Delay
This enables to configure the duration time for scanning LED power off, the
scanning LED will automatically turn off if duration time elapsed. This setting is
only available when the trigger mode is set as”
Good read off
” or
“Timeout
Off”
*
8172
*
0 ~ 4 minutes 15 Sec
1 sec
5 sec
(A) Scan “Enter” barcode
(B) Scan “LampOff Delay” barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 10 sec, the
parameter value is
10 sec / 1 sec =
10
Note: this configuration is only applicable when the scanner is in USB
cable mode.
7. General Configuration Setting
Procedure:
Example:
7- 8 LAMP OFF Delay
Configuration Range
Unit
Default Setting
Procedure:
Example:
