ENTER End
*/
$
%
ENT
*
*
ZEND
*
109
7-9 Good Read Time
This enables to set the scanning duration time for reading the same barcode
label, this function only available when the trigger mode is set in “
Continue
” or
“
Momentary
” or “
Alternate
” mode.(
Note:
when the configuration is set as
“0” or “00”, it means, no waiting time needed. User can scan the same
barcode label without any delay time
).
*
8112
*
0 ~ 25 sec
0.1 sec
0.5 sec
(
A) Scan “Enter” barcode
(B) Scan “Good Read Time” barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 1 sec, the
parameter value is
1 sec / 0.1 sec =
10
Note: this configuration is only applicable when the scanner is in USB
cable mode.
7. General Configuration Setting
7- 9 Good Read Time
Configuration Range
Unit
Default Setting
Procedure:
Example:
