ENTER End
*/
$
%
ENT
*
*
ZEND
*
110
7-10 Setup Timeout
This configuration enables to set the duration of scanner configuration time. If
user does not perform any actions after scanning the “Enter” barcode
(Configuration barcode) the setting mode will automatically exit.
*
0072
*
0 ~ 4 minutes 15 sec
1 sec
30 sec
(A) Scan “Enter” barcode
(B) Scan “Setup Timeout” barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 10 sec, the
parameter value is
10 sec / 1sec =
10
7-11 Vibrator Off Delay
This configuration enables to set the duration of vibrating time when the
barcode is successfully read and decoded. (
Note: this configuration is only
applicable with optional purchased vibrator installed, and Good read
Vibrator function set as “Enable” Chapter: 7-3-3
)
*
81
A
2
*
0-2.5 Secs
0.01 sec
0.1 sec
(A) Scan “Enter” barcode
(B) Scan “Vibrator Off Delay” barcode
(C) Scan Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 0.2 sec, the
parameter value is
0.2 sec / 0.01sec
= 20
7- 11 Vibrator OFF Delay
7. General Configuration Setting
7- 10 Setup Timeout
7- 11 Vibrator OFF Delay
Configuration Range
Unit
Default Setting
Procedure:
Example:
Configuration Range
Unit
Default Setting
Procedure:
Example:
