37
4. Memory / Bluetooth Mode
In the software, please go to
Sync
properties
COM PORT
for
synchronization.
Configure scanner Bluetooth parameters, including
Name
(user preferred
device name for the scanner),
Mac Address
from the third party Bluetooth
dongle or devices,
Password
(user preferred password), and make sure
Bluetooth connection
Mode
is set as corresponding selection code.
( please refer to Bluetooth mode selection code table section :4-2-4-1)
Save the configuration parameters, and download the settings to scanner
(File
Save
Communication
Download T-parm File)
Note:
User can also transfer the saved configuration to the scanner. The
procedure as following:
For synchronization procedure, please refer to above steps and select
File
Open (and selected your saved configuration file)
Download
T-parm File.
Exit the software, and disconnect the connection between Bluetooth
Setting software and scanner.
Note: for more detail, please refer to Bluetooth Setting instruction guide.
(CM500\manual\Bluetooth setting instruction guide.pdf)
User needs to configure the Mac
address, Mac Address can be
find from Bluetooth hardware
devices properties, for example:
(0011b109da77)
User can configured preferred
Bluetooth scanner name
User can configure preferred
password for Bluetooth
connection.
Please refer to 4-2-3 section for
Bluetooth mode selection code.
