ENTER End
*/
$
%
ENT
*
*
ZEN
D
*
73
6-2-5 Connect Off Time
Under the Bluetooth mode, when the Bluetooth connection is established while
the scanner is not working. This configuration enables to set the duration of
scanner sleep time. (
Note: Default value is 6 as 60 seconds
)
*
6042
*
0 ~ 42 Min 30secs
10 secs
6 (as 1 minute)
(A) Scan “Enter” barcode
(B) Scan “Connect Off Time” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 2 minutes, the
parameter value is
2 min / 10 sec =
12 ( 2minx 60 / 10sec = 12)
6-2-6 Lamp Off Delay
The configuration enables the setting of duration time of scanner LED power
on and off .
*
6052
*
0 ~ 4 minutes 15 sec
1 sec
5 sec
(A) Scan “Enter” barcode
(B) Scan “LampOff Delay” barcode
(C) Scan parameters from
Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
If configuration is 10 sec, the
parameter value is
10 sec / 1 sec =
10
6-2-5 Connect Off Time
6-2-6 Lamp Off Delay
6. Memory / Bluetooth General Setting
6-2-5 Connect Off Time
6-2-6 Lamp Off Delay
Configuration Range
Unit
Default Setting
Procedure
Example
Configuration Range
Unit
Default Setting
Procedure:
Example:
