www.flash-butrym.pl
2
1
INTRODUCTION
Thank you for purchasing LASER 4 HEADS RGBY BEAM. For safety reasons and to ensure the trouble-free
operation, carefully read the instructions.
2
SAFETY INFORMATION
1.
Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2.
Disconnect the power supply before installation.
3.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4.
Do not use the device in high humidity conditions and at temperatures above 40° C
5.
The device must be installed on stable structures
6.
The unit must be well protected against moisture, dust and shaking. Do not use the
product in dusty environment.
7.
The distance between lighting and illuminated object should be greater than 1 meter.
8.
Ensure the fan is not blocked.
9.
Do not look into the laser source.
10.
Do not turn the device on and off frequently.
11.
Please turn the unit off for 15 minutes after two hours of operation. Ensure that the laser
system is properly cooled.
12.
Do not touch the laser lighting with wet hands and do not pull the power line.
13.
Prevent the laser light from strong vibration.
14.
In case of any problems please contact your distributor.
15.
Be sure that the power supply parameters is matched with the parameters marked on the
device.
16.
Installation should be made by professional technician.
17.
Be sure that there is no flammable or explosive subject nearby.
18.
The distance from the light source and other object should be at least 0,5m (at least 15cm
from walls).
19.
Please check whether the fan and the ventilation holes are not blocked.
20.
If the device is suspended, make sure that the security cable is able to lift at least ten times
its weight.
21.
For security reasons it is important to properly ground the unit.
Warning! When installing the device make sure that it is mounted in a way that prevents the people from
the audience to look directly into the light. This carries the risk of eye damage.
Avoid contact with eyes. Never look at the laser equipment or directly in the laser beam.
Provisions concerning the use of the laser may vary depending on the country. User is legally responsible
for the use of the device depending on location / country.
