www.flash-butrym.pl
2
1
INTRODUCTION
Thank you for purchasing LED PAR 64 7x10W RGBW 4in1 ABS. For safety reasons and to ensure the trouble-
free operation, carefully read the instructions.
2
SAFETY INFORMATION
1.
Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2.
Disconnect the power supply before installation.
3.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4.
Do not use the device in high humidity conditions and at temperatures above 40° C
5.
To avoid damage please don't use organic solvents to clean the fixture shell.
6.
The device must be installed on stable structures
7.
It should be installed in a well-ventilated place, at a distance of 15cm or more from the walls.
Please check if the fan and ventilation holes are unobstructed.
3
PRODUCT INFORMATION
3.1
Specification
Power supply voltage: 100 - 240V
Voltage frequency: 50/60Hz
Diode type: 4in1
Number of diodes: 7
Diode power: 10W
Display: LED - 4 characters
Color: RGBW
Beam angle (min): 25°
Beam angle (max): 25°
Dimming: Linear: 0 - 100%
Number of DMX channels: 5 / 8
DMX standard: DMX 512
Control interface: 4 buttons
Operating modes: DMX512, Auto, Sound-controlled, Master / Slave, Manual color
AC IN: IEC - C14
AC OUT: IEC - C13
DMX IN: XLR - 3 pin
DMX OUT: XLR - 3 pin
IP Rating: IP20
Housing made: ABS
Cooling: Active
Height [cm]: 25
Width [cm]: 26
Depth [cm]: 9
