www.flash-butrym.pl
2
1
INTRODUCTION
Thank you for purchasing 2x Moving Head 7R FL-233 BEAM+ Case. For safety reasons and to ensure the
trouble-free operation, carefully read the instructions.
2
SAFETY INFORMATION
1.
Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2.
Disconnect the power supply before installation.
3.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4.
Do not use the device in high humidity conditions and at temperatures above 40° C
5.
The device must be installed on stable structures
WARNING! THE BULB IS HOT!
Please turn off or restart the device only after 20 minutes after turning off the lamp, once
it is fully cooled down. Frequent switching will reduce the life span of lamps and bulbs.
CAUTION! The head and yoke must be unlocked before operation! Check the pan/tilt
locks!
3
MAINTENANCE
1.
Regularly clean the fan and the fan cover to maintain good air circulation.
2.
After turning the unit off, wait 20 minutes before restarting to avoid overheating and damage
to electronic components.
4
PRODUCT SPECIFICATION
Power consumption: 350W
Power supply voltage: 100 - 240V
Voltage frequency: 50/60Hz
Lamp type: 7R
Display: Color LCD
Color: Color wheel - 14 white
ZOOM: No
Beam angle (min): 0°
Beam angle (max): 4°
Dimming: Linear: 0 - 100%
Prism: 16-facet, rotating
FROST filter: Yes
FOCUS: Electronic
GOBO wheel: 17 + open, gobo shake effect
PAN range: 540°
TILT range: 240°
Number of DMX channels: 16
DMX standard: DMX 512
