LED Double Derby 2x10W 4in1 RGBW F7300228
www.flash-butrym.pl
2
1
INTRODUCTION
Thank you for purchasing LED Double Derby 2x10W 4in1 RGBW. For safety reasons and to ensure the
trouble-free operation, carefully read the instructions.
2
SAFETY INFORMATION
1.
Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2.
Disconnect the power supply before installation.
3.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4.
Do not use the device in high humidity conditions and at temperatures above 40° C
5.
The device must be installed on stable structures
3
SPECIFICATION
Power consumption: 30W
Power supply voltage: 110-250V
Voltage frequency: 50/60Hz
Fuse: F7AL
Diode type: 4in1
Number of diodes: 2
Diode power: 10W
Display: LED - 4 characters
Color: RGBW
ZOOM: No
Dimming: Linear: 0 - 100%
Number of DMX channels: 8
DMX standard: DMX 512
Control interface: 4 buttons
Operating modes: sound-activated, Auto, Master/Slave, DMX
Features: microphone sensitivity by a potentiometer
AC IN: IEC - C14
DMX IN: XLR - 3 pin
DMX OUT: XLR - 3 pin
Cooling: Active
Height [cm]: 22
Width [cm]: 20
Depth [cm]: 16
Set includes: power cable
4
INSTALLATION
After removing the packaging, check if the device was not damaged during transport. Before connecting to
the mains, make sure that the device is securely mounted. The manufacturer is not responsible for damage
caused by unstable mounting.
