150718
PL
YFL
Y
rev
A_GoKart
| Augu
st 7, 20
15 5:0
8 PM
29. Using pliers, hook the other end of the extension spring to
the throttle return clip.
Note
the location of the extension spring.
30. Secure the throttle return clip to the engine using a screw.
‒
Use 1 M6 screw.
‒
Total 1 location
Note
the location of the throttle return clip.
31. Slightly loosen this nut so that the throttle can move freely
when the gas pedal is pressed.
Note
the location of the nut.
32. Continue to feed the throttle control cable all the way
through to
5
.
Note
the location of the throttle control cable.
33. Secure the throttle control cable using the
throttle cable clamp at the bottom of
5
.
‒
Be sure the control cable is taut, before tightening the
throttle clamp.
34. Secure the green cable fully at the start location of the
throttle linkage.
35. Test the gas pedal to ensure proper movement of throttle.
36. Place part 57 over part 56.
Note
the location part 57.
37. Secure part 57 to part 56, using sheet metal screws.
‒
Use 4 sheet metal screws.
‒
Total of 4 locations.
38. Place part 58.
Note
the location part 58.
39. Secure part 58 to part 57, using sheet metal screws.
‒
Use 4 sheet metal screws.
‒
Total of 4 locations.
!
1
!
5
56
57
58
57
56
10 Putting the go‑kart together
Summary of Contents for plyfly
Page 1: ...For Ages 12 PlyFly Go Kart Instruction Guide 2015 Release HOW TO BUILD YOUR PLYFLY GO KART...
Page 64: ...150718 PLYFLY rev A_EM August 7 2015 5 06 PM 60 11 Master List...
Page 76: ...150718 PLYFLY rev A_Legal August 5 2015 10 3 8 PM 72 12 Legal...
Page 78: ...150718 PLYFLY rev A_Terms Conditions A u g u s t 5 2 0 1 5 1 0 3 8 P M 74 13 Terms Conditions...
