5.3
OPERATING THE STOVE - REMOTE CONTROL MODELS
5.3.1
Ensure valve power isolation switch is in the on position - see figure 6
Hold the handset with one hand ensuring your hand is wrapped around
the back and that your hand is in contact with both sides of the handset.
The green light of the “unlock” symbol should light. See figure 2 below.
Fig. 2
5.3.2
Press and hold the power button continuously until the word “PILOT”
appears at the bottom left of the display as shown overpage in figure
3, (this typically takes two seconds). The burner will now light at
maximum heat input level and will display “MAX” in the bottom left hand
side of the display as shown in figure 3 overpage.
For most efficient
performance leave the stove on high when lighting from cold for
ten minutes.
NOTE : If the power button is pressed for too long or too short a time or
the grip on the handset is not firm or is released too soon, the lighting
sequence will be interrupted and not complete. The reason for the
remote control having this strict start sequence is for safety reasons
so that the starting operation of the stove will be most unlikely to be
done other than intentionally by an adult.
37
Power button
Unlock symbol
(illuminates green)
Light sensor (for
display back light)
+ button (increases
heat input level)
- button (decreases
heat input level)
Day of the week
Time (12hr or 24hr display)
Room temperature
To change handset settings
(see section 3.6)
To change mode
(see section 3.6)
Range symbol - missing if
handset is not in range or
if stove control is turned
off
Gas stove burner status
Battery condition (RC
denotes handset, FC
denotes control valve on
stove)
