Supplied By www.heating spares.co Tel. 0161 620 6677
Operation Of Heater
The heater is operated via the use of three switches situated
on the left hand side of the canopy.
Switch No
Marking
Operation
Switch On
O I
On / Off. Depress to I,
this operates the flame
effect.
Switch Two
I
1kW heat setting and
Fan
Switch Three
II
2kW heat setting and
Fan
All three switches are mechanically linked, therefore when
switch one is turned off, all switches are turned to Off.
Note:
When turning off the heat settings it may be
necessary to wait for the fire to ‘reset’ before
turning heat settings back on. This is due to the
normal operation of the ‘safety cut-out’ device.
IMPORTANT
Safety Cut Out
This appliance is fitted with an automatic safety cut out. This
operates if the air outlet beneath the canopy becomes
covered or blocked. This will prevent the fan heater from
operating.
In order to RESET the appliance the following procedure
should be followed:-
Switch OFF the appliance and disconnect the appliance
from the mains supply
Leave the appliance disconnected for a MINIMUM of 10mins
Check the appliance is free from all obstructions and remove
safely
Switch ON the appliance at the mains supply socket
