background image

WARRANTY

FLC  Electronics  warrants  that  this  product  will  be  free  from  defects  in 
materials  and  workmanship  for  a  period  of  two  years  from  the  date  of  the 
shipment. 

If  any such product proves defective during this warranty period, FLC Electronics, at its 
option, either will repair the defective product without charge for parts and labour, or will 
provide a  replacement  for  the  defective  product.  In  order  to  obtain service under  this 
warranty,  Customer  must notify FLC Electronics of  the defect before the expiration of 
the warranty period and make suitable arrangements for the performance of  the service. 
Customer  shall  be  responsible  for  packing  and  shipping  the  defective  product  to  the 
service  center  designed  by  FLC  Electronics,  with  shipping  charges  prepaid.  FLC 
Electronics shall pay for the return of the product to the Customer if the shipment is to a 
location  within  the  country  in  which  the  FLC  Electronics  service  center  is  located. 
Customer shall be responsible for paying all shipping charges, duties, taxes, and any other 
charges for products returned to any other locations. 

This warranty shall not apply to any defect, failure or damage caused by improper use or 
inadequate  maintenance  and  care.  FLC  Electronics  shall  not  be  obligated  to  furnish 
service under this warranty:

• to  repair  damage  resulting  from  attempts  by  personnel  other  than  FLC  Electronics 

representatives to install, repair or service the product; 

• to  repair  damage  resulting  from  improper  use  or  connection  to  incompatible  equip-

ment;

• to service a product that has been modified or integrated with other products when the 

effect of such modification or integration increases the time or difficulty of servicing 
the product.

This warranty is given by the FLC Electronics with respect to this product in lieu of  any 
other  warranties,  expressed  or  implied.  FLC  Electronics  and  its  vendors  disclaim  any 
implied  warranties  of  merchantability  or  fitness  for  a  particular  purpose.  FLC 
Electronics’  responsibility  to  repair  or  replace  defective  products  is  sole  and  exclusive 
remedy  provided to the  customer  for  breach  of  this  warranty.  FLC  Electronics and  its 
vendors will  not be liable for  any  indirect,  special,  advance notice  of  the possibility  of 
such damages.

The instrument may generate hazardous voltage levels! It should be operated by qualified 
personnel only. The instrument is to be used in normal room temperature and humidity.

The  manufacturer  cannot  be  held  responsible  for  damage  to  any  device  connected  to  the 
instrument.  It  is  recommended  that  samples  or  equipment  sensitive  to  voltage  spikes  are 
disconnected from  the high-voltage  outputs when turning the power to the instrument ON or 
OFF.

ELECTRONICS AB

WWW.FLCE.SE

Summary of Contents for A400X










Reviews: